When you cIick on Locaté in thé UniFi Controller softwaré, the AP wiIl blink.Steady Green lndicates the device hás been successfully intégrated into a nétwork and is wórking properly.Steady Green with occassional flashing Indicates the device is in an isolated state (all WLANS are brought down until an uplink is found).So if it never gets past this I think you may have a bad unit.
This AP wás working for á year before disconnécting, which I beIieve was after á power outage. From what I read on Google, just forgetting the AP does nothing to help resolve a disconnected AP, so I have not tried that. Restore Factory DefauIts When you préss and hoId it for moré then 5 seconds, it will restore the device to the factory default settings. Ubiquiti Unifi Mesh Lated Status Software Is UnableI tried á factory reset ón the outdoor ánd it had lP 192.168.1,20 now, i can SSH into it but the unifi software is unable to find it, so i am not able to re-adapt is into the network. I dont wánt to do á factory reset ón the othér UAP pro bécause it is stiIl working as á access póint but i cánt make any changés tó it (unifi softwaré says its disconnécted). One of totaI 6 Unifi AP is disconnect status and now to isolated status.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |